collection message map

Hello, welcome toFoshan City is a standard tool Limited!

Foshan City is a standard tool Limited--Commodity is high quality as the right way, Italy is a benchmark mark

0757 support hotline 81267033

hot key words: Product Categories
Auto repair practical tips - homemade tools articles
current location:Home » Auto repair practical tips - homemade tools articles

Auto repair practical tips - homemade tools articles

返回列表 source:admin View the phone URL
Auto repair practical tips - homemade tools articlesscan it
Browse:1006 Release date:2017-08-03【Big normal small

On the way to the car, the conditions are limited circumstances we will inevitably do some easy to do their own maintenance tools. Here we take a look at what we have done the tools, what we use it?


1, BMW 760 car door valve repair tool




PS: We do not have to remove the cylinder door oil seal, in the car easy to get. Xiao Bian had done before, but is a simple, as shown below, but there is no red circle part, that is, to do a stent, the use of carry the principle of pushing the valve spring. It is worth noting that this valve door seal, to sub-cylinder to. For example, four-cylinder engine for the 1, 4-cylinder valve oil seal, you must let the 1,4-cylinder piston at the top dead center, in order to disassemble the valve spring, or valve into the cylinder, waiting to lift the cylinder head.




2, double camshaft positioning tool




PS: a pair of double camshaft timing belt, bad change? The The DIY, easy to get.


3, the ignition signal detection tool


PS: Xiaobian that this is very good, very creative, this is the use of relay control coil enameled wire, in a paper tube around a lot of circle, and then fixed with tape protection, the two feet connected to the coil A light-emitting diode, make full use of the principle of mutual inductance in the electromagnetic principle.


The use of this method is to close the ignition switch, the key from the middle through, when we switch the key, the key chip induction coil sensor to the chip, resulting in point flow at the same time, will produce a mutual inductance in the coil coil, light-emitting diodes will flash.


4, disassemble oil filter tool




PS: the use of abandoned timing belt, do simple tools Oh.


5, self-made pry card tools, with the lever up




PS: make full use of the replacement of waste to make their own want to use the tool, this is the use of the rear box or the hood of the hydraulic rod made out.


6, do their own T pole, is easier to buy than buy




PS: the same is done with a hydraulic rod and a sleeve.


7, homemade test lights




PS: This is the use of two different models of different colors of light-emitting diodes and a 600Ω resistor to do, the two diodes in reverse connection, that is, either positive or negative will have a light.


Let's take a look at the little partner's work




Use a bottle to make a shade, protect the bulb, and think of a stick. One end made of a pointer, the other end made the clip is more useful.




See this, the first feeling is pretty beautiful, haha ~ there is a pen cover to protect the needle.


8, homemade oil collector




PS: I just want to say, get so many things, a little redundant, we put the oil, the body down, and then a tub, all get.


9, homemade pumping unit




PS: manual type: with this brake oil, called a cool. My mother no longer worry about my demolition of the brake when the pump is full of oil.


After reading the manual, we come to an automatic.




PS: Xiaobian just want to say that this vacuum pump will not be a little high cost ah, then you determine how much oil can be installed, change the oil but also tossing back and forth several times. At the beginning, Xiaobian, but with a hand-push fire extinguisher to do a pumping unit, then we used the air conditioning pumping the pump, but unfortunately did not take pictures, a little regret.


Foshan City is a standard tool Limitedall rights reserved 粤ICP备17063786号-1
support hotline:0757-81267033  tel:18900862823  fax:0757-81267033
address:Nanhai District, Foshan City, Guangdong Province, Luo Village Road, Guangdong new light source industrial base A3 building on the first floor  E-Mail:
Production:企划动力

二维码